Publicidad
Idiomas disponibles
Idiomas disponibles
Leaking batteries/batteries may damage the product. Remove the batteries/batteries when
•
not using the device for an extended period of time.
Improper use of the batteries/batteries may cause explosion and leakage of battery fluid.
•
Do not attempt to short-circuit the terminals or batteries/batteries.
•
Recycle batteries/batteries if necessary. Return batteries/batteries to a government-
•
approved collection point for recycling.
Do not expose batteries/batteries to high temperatures or excessive heat.
•
3. INSTRUCTIONS FOR USE
3.1 Before first use
Choose a suitable location for using the product.
•
If the product is tilted more than 45° during transport, leave it upright for at least 24 hours
•
before starting it.
Place the product on a firm, level surface
•
in a room with at least 1 meter of free
space around it for proper air circulation.
Do not use the product near walls,
•
curtains or other objects that may block
the air inlet and outlet. Keep the air inlet
and outlet free of obstacles.
Never install the product where it may be
•
exposed to:
Heat sources such as radiators, heating grills, stoves or other products that produce heat.
•
Direct sunlight.
•
Mechanical vibration or shock.
•
Excessive dust.
•
Lack of ventilation, such as a closet or bookcase.
•
Uneven surface.
•
ATTENTION!
◊
Install the product in areas larger than 10 m².
◊
Do not install the product where flammable gas may leak.
3.2 Installing the window seal for a sliding window
The product should be vented to the outside to allow exhaust air to escape from the space
coming out of the product containing waste heat and moisture.
1.
Adjust the length of the window seal to match the length of your window. Connect the
exhaust hose to the window seal, as shown in image 1.
2. Close your window to secure the window seal. If necessary, secure the window seal more
firmly with duct tape. Close the gap between the connection to allow the product to work
optimally, as shown in image 2.
3. Attach the hose connector to one end of the exhaust hose, as shown in image 3.
4. Attach the window seal to the other end of the exhaust hose, as shown in image 4.
36
1 m
Publicidad
