Stanley SCD10 Manual De Instrucciones página 31

Ocultar thumbs

página de 40

/ 40
Marcadores

Idiomas disponibles

from any heat source. The charger is ventilated

through slots in the top and the bottom of the

housing.

• Do not operate charger with damaged cord or

plug — have them replaced immediately.

• Do not operate charger if it has received a sharp

blow, been dropped, or otherwise damaged in

any way. Take it to an authorised service centre.

• Do not disassemble charger; take it to an

authorised service centre when service or repair

is required. Incorrect reassembly may result in a risk

of electric shock, electrocution or fire.

• In case of damaged power supply cord the

supply cord must be replaced immediately by the

manufacturer, its service agent or similar qualified

person to prevent any hazard.

• Disconnect the charger from the outlet before

attempting any cleaning. This will reduce the risk

of electric shock. Removing the battery pack will

not reduce this risk.

• NEVER attempt to connect 2 chargers together.

• The charger is designed to operate on standard

household electrical power. Do not attempt to

use it on any other voltage. This does not apply to

the vehicular charger.

Batteries

• Never attempt to open for any reason.

• Do not expose the battery to water.

• Do not store in locations where the temperature may

exceed 40 °C.

• Charge only at ambient temperatures between 10 °C

and 40 °C.

• Charge only using the charger provided with the tool.

• When disposing of batteries, follow the instructions

given in the section "Protecting the environment".

Chargers

• Use your STANLEY charger only to charge the

battery in the tool with which it was supplied. Other

batteries could burst, causing personal injury and

damage.

• Never attempt to charge non-rechargeable batteries.

• Have defective cords replaced immediately.

• Do not expose the charger to water.

• Do not open the charger.

• Do not probe the charger.

SAVE THESE INSTRUCTIONS

Chargers

The SC101 chargers accept 12V Max Li-Ion batteries.

These chargers require no adjustment and are designed

to be as easy as possible to operate.

Charging Procedure (Fig. B)

1. Plug the charger into an appropriate outlet before

inserting battery pack.

2. Insert the battery pack into the charger. The charging

light will blink continuously indicating that the

charging process has started.

3. The completion of charge will be indicated by the

charging light remaining ON continuously. The pack

is fully charged and may be used at this time or left

in the charger.

NOTE: To ensure maximum performance and life of Li-Ion

batteries, charge the battery pack fully before first use.

Charging Process

Refer the table below for the state of charge of the battery

pack.

State of charge

charging

fully charged

hot/cold pack

defect battery

Hot/Cold Pack Delay

When the charger detects a battery that is too hot or too cold,

it automatically starts a Hot/Cold Pack Delay, as shown in

'State of charge', suspending charging until the battery has

reached an appropriate temperature. The charger then au-

tomatically switches to the pack charging mode. This feature

ensures maximum battery life.

The tool will automatically turn off if the Electronic Protection

System engages. If this occurs, place the Li-Ion battery on

the charger until it is fully charged.

LI-ION BATTERY PACKS ONLY

Li-Ion batteries are designed with an Electronic Protection

System that will protect the battery against overloading,

overheating or deep discharge.

The tool will automatically turn off if the Electronic

Protection System engages. If this occurs, place the Li-Ion

battery on the charger until it is fully charged.

English (original instruction)

SC101

green blink

green solid

red blink

red

solid

red

solid

red

solid

red solid

red

solid

Stanley SCD10 Manual De Instrucciones página 31

Idiomas disponibles

Manuales relacionados para Stanley SCD10

Productos relacionados para Stanley SCD10