Publicidad
Idiomas disponibles
Idiomas disponibles
English (original instruction)
3. Torque adjustment collar
4. Gear shifter
5. Keyless chuck
6. Battery release button
7. Battery pack
8. Worklight
9. Fuel Gauge
INTENDED USE
This drill/driver is designed for light fastening and drilling
applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This drill/driver is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities, or for lack of
experience and/or for want of knowledge or skills
unless they are supervised by a person responsible
for their safety. Children should never be left alone to
play with this product.
ELECTRICAL SAFETY
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also make
sure that the voltage of your charger corresponds to that
of your mains.
Your STANLEY charger is double insulated in
accordance with IEC60335; therefore no earth
wire is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY
service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data).
The minimum conductor size is 1 mm
length is 30 m.
When using a cable reel, always unwind the cable
completely.
34
Assembly and adjustments
Inserting and Removing the
Battery Pack from the Tool (Fig. C)
NOTE: Make sure your battery pack (7) is fully charged.
Fitting And Removing The Battery
Instructions for Use
Proper Hand Position (Fig. A, H)
; the maximum
2
Proper hand position requires one hand on the main
handle.
WARNING: Prior to assembly and
adjustment, always remove the battery pack.
Always switch off the tool before inserting or
removing the battery pack.
WARNING: Use only STANLEY battery
packs and chargers.
WARNING: To reduce the risk of serious
personal injury, place the forward/reverse
button in the lock-off position or turn tool
off and disconnect battery pack before
making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
• To fit the battery (7), line it up with the receptacle
on the tool. Slide the battery into the receptacle and
push until the battery snaps into place.
• To remove the battery, push the release buttons (6)
while at the same time pulling the battery out of the
receptacle.
OPERATION
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of serious
personal injury, place the forward/reverse
button in the lock-off position or turn tool
off and disconnect battery pack before
making any adjustments or removing/
installing attachments or accessories.
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper hand
position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Publicidad
