Ryobi RYGUT Manual Del Operador página 9

„ The blower produces a strong air blast when operated at
full speed. Speed is controlled by the amount of switch
trigger depression.
NOTE: Increase trigger pressure on the powerhead for
increased air speed and decrease pressure for decreased
air speed.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off motor, wait for all moving parts to stop, and
disconnect from power supply. Failure to follow these
instructions can result in serious personal injury or prop-
erty damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
When servicing, use replacement parts that meet or
exceed original product specifications. Use of any other
parts can create a hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
OPERATION
„ In many situations it is not necessary to use the full power
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
ATTACHING THE STORAGE HANGER
See Figure 5.
There are two ways to hang the attachment for storage.
„ To use the hanger cap, push in the button and place the
„ The secondary hole in the attachment shaft can be used
STORING THE ATTACHMENT
„ Store the attachment indoors in a dry, well-ventilated
„ Keep away from corrosive agents such as garden chemi-
7 — English
of the blower; in fact it is not advisable in some applica-
tions. When using the blower in tight quarters, such as
corners of patios and garages, full power is not usually
required. A somewhat slower speed will do the same job
effectively without the turbulence created by full power
operation. This turbulence only carries the blown material
back into the corner and produces floating dust.
WARNING:
hanger cap over the end of the attachment shaft. Slightly
rotate the cap from side to side until the button locks
into place.
for hanging purposes as well.
place that is inaccessible to children.
cals and de-icing salts.