ERSA i-CON 2V MK2 Manual Breve página 24

Intended use
Danger of fire and electric shock!
Humidity and moisture conduct electricity. This may lead to fires and electric
shock.
Fire hazard due to unattended soldering station!
Avoid any risk of injury!
Risk of accidents! Danger due to use by unauthorised persons!
2. Intended use
The i-CON 1 soldering tool was designed according to the state of the art and ap-
proved technical safety regulations. However, residual risks may originate from the
soldering tool, especially if it is operated improperly by untrained personnel or
used for purposes other than those it is intended for.
Ersa GmbH
WARNING
a) Protect the device from moisture and humidity!
b) Do not switch on wet or humid soldering tools!
WARNING
a) Keep any unauthorised people at a safe distance from the soldering station to
prevent accidents and burns!
b) Never leave the soldering station unattended when running!
c) The soldering tool must be placed in the storage position on the support
stand provided for this purpose.
d) After switching off the soldering station, the soldering tool requires time to
cool down.
CAUTION
a) Check the work tool for damage before switching it on!
b) Operate and store the work tool only under the ambient conditions specified
in the data sheet!
c) Service and clean the work tool as provided for in the operating instructions!
d) Keep the workplace tidy!
CAUTION
a) Ensure that unauthorised persons, especially children, do not have access to
the soldering station!
3BA00270 | Rev. 1 7