ERSA i-CON 2V MK2 Manual Breve página 29

6.2 Selection of the soldering tool
Select the desired soldering tool by pressing i-OP. Repeatedly pressing i-OP will ac-
tivate either the soldering tool connected to the left or the one connected to the
right.
6.3 Set soldering tip temperature
6.4 The Work mode
After the station has been switched on, the switch-on dialog is displayed for ap-
prox. 2 seconds.
12
e) Turn the i-OP to select the entry [Change].
f) Select the [Language] menu item and then press the i-OP.
g) Turn the i-OP to select the desired language, then press the i-OP.
h) Select the menu item [** END **] and then press the i-OP.
ð The national language has thus been changed.
a) Turn the i-OP to adjust the desired soldering tip temperature.
b) Press the i-OP.
ð The soldering tip temperature changes.
3BA00270 | Rev. 1
Function description
Ersa GmbH