Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Technical Data
Safety advice
ENGLISH
You demand the best and buy quality - quality provided by Atlas Copco. We have
built for you a reliable and lasting tool. Working effectively and without endangering
your health is only possible if this instruction for use is read carefully before first us-
ing the tool. We want to satisfy our customers and would like you to buy again AEG
Electric Power Tools from Atlas Copco.
Type
Nominal power (W)
Min. no-load speed (min
Max. no-load speed (min
Grinding disk diameter (mm)
Thread of work spindle
Weight (kg)
Speed control
No-load speed limiter
Please pay attention to the safety instructions in the attached leaflet!
Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
Always disconnect the plug from the socket before carrying out any work on the ma-
chine.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
Before use check machine, cable, and plug for any damages or material fatigue. Re-
pairs should only be carried out by authorised service agents.
Allow the machine to come to a stop before putting down.
Dust that arises when working in stones with crystalline silicic acid can damage your
health. Do not work on any material containing asbestos. Please note the safety reg-
ulations, VBG, of the employer's liability insurance association.
Never reach into the danger area of the machine when it is running.
Always wear safety goggles and ear protectors when working with this machine. It
is further recommended to wear safety gloves, apron, as well as sturdy non-slipping
shoes.
Always use the additional handle.
Always use the protecting cap when roughing-down and separating.
Only use tools whose permitted speed is at least as high as the highest no-load
speed of the machine.
Check grinding tools before use. The grinding tool must be properly mounted and
turn freely. Perform a test run for at least 30 seconds without load. Do not use dam-
aged, out of round or vibrating grinding tools.
When grinding metal, flying sparks are produced. Take care that no persons are en-
dangered. Because of the danger of fire, no combustible materials should be locat-
ed in the vicinity (spark flight zone). Do not use dust extraction.
Due care should be taken that no sparks or sanding dust flying from the workpiece
come into contact with you.
Pay attention to the dimensions of the grinding disc. The mounting hole diameter
must fit the mounting flange without play. Do not use reducer pieces or adapters.
Never use a cutting disc for grinding. Do not subject cutting discs to side pressure.
When separating stone the guide shoe must be used!
2
WS 650-
115
650
-1
)
-1
)
10000
115
M14
1,5
WS 650-115, WS 715-115, WS 715-125, WSE 800-125
WS 715-
WSE 800-
115
125
710
710
10000
10000
115
125
M14
M14
1,5
1,5
125
800
2700
10000
125
M14
1,5
•
•
Publicidad
