4. Turn off the water to your washing machine.
5. Disconnect the end of your existing water hose (1) from the washer and connect it to the water inlet
port of the ozone generator. Tighten the connection but do not over-tighten. Leave the other end
connected to your water source. If the existing hose is not in good condition, replace with a new one.
6. Attach one end of the included hose (2) to the water outlet port A of the ozone generator and the
other end to the water inlet port of the washing machine. Use pliers to tighten both ends, but do not
over-tighten. If there is a hot water hose, leave it as originally installed.
7. You can attach another hose to the water outlet port B if you wish, using ozone-treated water for
more other purposes like washing pets.
8. Slowly turn on the water supply and carefully check all connections, ensuring that there are no leaks.
If leaks exist, reattach the hose and ensure that the junctions are properly aligned. If the junction
continues to leak, use Teflon tape to achieve a tight seal.
9. Plug the power cable into the ozone generator and plug it into the power outlet. When connected, the
ozone generator will power on with a beep sound and then enter standby mode. It will automatically
work when the washing machine begins to wash.
OUT
IN
Machine à laver
robinet
(1)
(2)
37