Publicidad
Idiomas disponibles
Idiomas disponibles
Description
Program
Of Cycle
Prewash(45
Wash(70
Rinse
Self-
Rinse(70
cleaning
Drying
NOTE :
(*EN60436)
Starting A
Draw out the lower and upper basket, load the dishes and push them back.
1.
It is commended to load the lower basket first, then the upper one.
Pour in the detergent.
2.
Insert the plug into the socket. The power supply refer to last page "Product fiche".
3.
Make sure that the water supply is turned on to full pressure.
Close the door, press the Power button, to switch on the machine.
4.
Choose a program, the chosen program number will show in the screen. Then
5.
press the Start/Pause button, the dishwasher will start its cycle.
Changing The Program Mid-cycle
A program can only be changed if it has been running only for a short period of
time, otherwise the detergent may have already been released or the the wash
water with detergent has already been drained. If this is the case, the dishwasher
needs to be reset and the detergent dispenser must be refilled.
dishwasher, follow the instructions below:
Press the Start/Pause button to pause the washing
1.
Press Program button more than three seconds the machine will be in
2.
program selection mode
You can change the program to the desired cycle setting.
3.
4. Press the Start/Pause button ,the dishwashwe will start after a few seconds
EN
Detergent
Pre/Main
)
℃
)
4/14g
℃
(1
)
or 2
℃
The ECO program is suitable to clean normally soiled tableware, that
:
for this use, it is the most efficient program in terms of its combined
energy and water consumption, and it is used to assess compliance
with the EU ecodesign legislation.
Program
.
3 sec
Running
Time(min)
Wash
145
tabs
15
Energy
Water
(kWh)
(L)
1.255
13.2
To reset the
Rinse
Aid
Publicidad
