Publicidad
Idiomas disponibles
Idiomas disponibles
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended
oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, or SG rated SAE 10W-30 weight.
Other viscosity oils shown in the chart may be used
when the average temperature
in your area is within
the recommended
range.
-20
0
20
40
60
80
100°F
I
I
!
I
I
I
I
I
-30 -20
-10
0
10
20
30
40°C
AMBIENT TEMPERATURE
•
Place pressure washer on a level surface.
•
Clean area around oil fill, remove oil dipstick and
wipe it clean.
•
Insert and remove the dipstick without screwing it
into the filler neck.
OIL FILLER CAP/DIPSTICK
I LIMIT
•
Slowly pour oil into oil fill opening until oil reaches
"UPPER LIMIT" mark on the dipstick. Stop
occasionally to check oil level.
•
If the oil level is near or below the lower limit mark
on the dipstick, fill with the recommended
oil to the
upper limit mark. DO NOT OVERFILL.
•
Install oil dipstick, hand tighten securely.
NOTE: Check oil often during engine break-in.
Add Gasoline
,_
WARNING!
Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
Not smoke when filling fuel tank.
,_
WARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away
any fuel spillage from engine and equipment
before starting.
•
Use fresh, clean unleaded automotive gasoline and
store in approved, clean, covered containers. Use
clean fill funnels. Never use "stale" gasoline left
over from last season or gasoline stored for long
periods.
•
Clean area around fuel fill cap, remove cap.
•
Slowly add gasoline to fuel tank. Use a funnel to
prevent spillage. Fill tank to "Fuel Level Mark" as
shown below.
•
Install fuel cap and wipe up any spilled gasoline.
Connect
Hose and Water
Supply to Pump
IMPORTANT: You must assemble nozzle extension
and attach all hoses before you start engine. Starting
engine without all hoses connected and water supplied
will damage pump.
•
Attach quick connect to your high pressure hose by
inserting threaded portion into hose end and hand
tighten.
/
Publicidad
