Publicidad
Idiomas disponibles
Idiomas disponibles
13. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault
Possible cause
The equipment does
• Correct starting procedure not followed
not start
• Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
The equipment starts
• Incorrect choke lever setting
but does not develop
• Soiled air filter
its full power
• Incorrect carburetor setting
• Cutting blade blunt
The engine does not
• Incorrect electrode gap on the spark plug
run smoothly
• Incorrect carburetor setting
Engine smokes exces-
• Incorrect fuel mix
sively
• Incorrect carburetor setting
If the temperature of
• Engine is overloaded
machines is too high
32 | GB
Remedy
• Follow the instructions for starting
• Clean the spark plug or replace it with a new
one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
• Turn off the choke lever
• Clean the air filter
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
• Clean the spark plug and adjust the electrode
gap, or fit a new spark plug
• Contact an authorized customer service outlet
• Use the correct fuel mix (see fuel mixing table)
• Contact an authorized customer service outlet
• Insure the machines have rest at regular time
www.scheppach.com
Publicidad
