Brandson Equipment 306535 Manual Del Usuario página 23

11 Protective grid lock nut
12 Rotor blade
13 Rotor fixing screw (left­hand thread)
14 Front guard grille
5. assembly
Remove the fan from the packaging and check the unit and the scope of delivery
listed in the table. Please contact the seller if any part is missing or damaged.
1. To mount the fan correctly, first screw the stand (7, 8) to the outer tube (6).
Take the stand (7) and screw the outer tube (6) to the stand from below using
the fastener (8).
2. To connect the motor unit (1), to the inner tube (4), insert it into the fan control
inlet and secure it with the inner tube fixing screw (3).
3. Now place the rear protective grille (10) on the fan unit (9).
4. Screw the rear grille in place using the locking nut (11).
5. Then put the rotor blade (12) on the motor axle (9) and fasten it with the
appropriate fastening screw (13). Make sure that the individual components are
mounted properly on the motor axle (9) to avoid vibrations!
6. Align the locking device of the front guard with the illustrated position of the
rear guard (see illustration below left).
7. Press the guards one after the other with both hands.
English
23