Brandson Equipment 306535 Manual Del Usuario página 24

8. Finally, tighten the safety screw of the fan grille (see illustration below right).
Note: Screws, if they are not in the bag, are usually all pre-assembled in the place
where they would otherwise be.
6. Use
Place the fan in a suitable location and connect the unit to a properly installed
220­240V AC socket.
By tilting the protective cage, you can change the angle of inclination by up to 25°
as desired.
Press the „Oscillation" key ( ) on the control element or on the remote control
to switch on the oscillation.
The fan has 12 different speed levels, which you can change with the „speed
level" button ( ) on the control element or on the remote control. The current
speed level is shown in the display.
Attention: The display switches off automatically after a period of 30 seconds
without operation, and can be reactivated by e.g. pressing the speed step key !
24
English