Teka MaestroPizza HLC 8510 P Manual Del Usuario página 44

Pyrolysis self-cleaning function
WARNING
Before running the pyrolysis cleaning cycle,
please read the safety instructions given at
the start of the Installation and Maintenance
manual closely.
This function allows you to run a pyrolysis clean-
ing cycle during which, due to the high tempera-
tures reached inside the oven, the accumulated
grease is carbonized.
As a general rule, a pyrolysis cycle should be run
every 4-5 cooking cycles, using the most suit-
able program for the amount of dirt in the oven.
The more dirt, the longer the program.
During the pyrolysis cycle, the light inside the
oven remains off.
PROGRAM THE PYROLYSIS FUNCTION
IMPORTANT
Before starting the pyrolysis function, you
must remove all the accessories and dishes
from the oven, including the supports of the
tray and/or telescopic guides. Follow the in-
structions given in the Installation and Main-
tenance Manual provided with your oven.
WARNING
Remove any spills or excess dirt from the in-
side of the oven, as these could catch fire
during the pyrolysis function with the conse-
quent risks.
WARNING
Before starting the pyrolysis check that the
oven door is correctly closed.
1. Turn the cooking control dial to Pyrolysis:
.
2. After a few seconds, symbol
on the clock display and indication P2 is
read (pyrolysis program 2).
44
User Guide
3. Now you can change the pyrolysis program
to P1, P2, P3 using keys
P1: Mild pyrolysis. One hour.
P2: Normal pyrolysis. One and a half hours.
P3: Intensive pyrolysis. Two hours.
4. After selecting the required program, press
. Immediately afterwards, the automatic
door lock is activated.
If the door is not correctly closed, it will not
lock, an alarm is heard and the pyrolysis will
not start.
If this happens, switch off the alarm by press-
ing any key on the clock, close the door cor-
rectly, turn the control dial to
the pyrolysis program again, following the
instructions above.
5. When the door is locked, symbol
up on the clock display and the time re-
maining until the end of the pyrolysis func-
tion is displayed.
At this point, the oven is programmed and
runs the pyrolysis cleaning cycle. While this
cycle is running, it is not possible to select
any of the oven clock functions, except the
child safety function.
Do not try to open the oven door as this may
interrupt the cleaning process.
6. When the pyrolysis cleaning ends, a beep is
heard, symbol
played on the clock.
7. Press any key on the clock to stop the
beeping.
8. Turn the control dial to position
9. The oven heating process has ended.
lights up
However, the oven is too hot and cannot
be used.
WARNING
IMPORTANT
flashes and 0:00 is dis-
or :
and select
lights
.