Sanding Sheets without Velcro Backing
(see figure A— C)
Press the release button 5 and keep it depressed.
Guide the sanding sheet 4 to the stop under the
opened front clamping bracket 6 and let go of the
release button 5 again. Pay attention that the sand-
ing sheet is clamped centrally.
Press the sanding sheet clamp 3 inward and pivot
it to the stop.
Fold the sanding sheet 4 firmly around the sanding
plate. Guide the other end of the sanding sheet 4
between the rear clamping bracket and the red
roller on the clamping bracket 3.
Hold the sanding sheet tensely and press the
clamping bracket 3 toward the sanding plate to
lock the sanding sheet.
Sanding sheets without holes, e. g. from rolls or by the
meter, can be punctured with the perforating tool 13.
For this, push the power tool with the sanding sheet
mounted onto the perforating tool (see figure F).
To remove the sanding sheet 4, loosen the clamping
bracket 3 and pull out the sanding sheet from the rear
holding fixture. Press the release button 5 and com-
pletely remove the sanding sheet.
Operation
Starting Operation
Observe correct mains voltage! The voltage of the
power source must agree with the voltage specified on
the nameplate of the machine. Power tools marked with
230 V can also be operated with 220 V.
Switching On and Off
To start the machine, tilt the On/Off switch 7 toward
the right to the "I" position.
To switch off the machine, tilt the On/Off switch 7
toward the left to the "0" position.
Operating Instructions
B Wait until the machine has come to a stand-
still before placing it down.
The removal capacity during sanding is mainly deter-
mined by the selection of the sanding sheet.
Only flawless sanding sheets achieve good sanding
capacity and extend the service life of the machine.
Pay attention to apply uniform sanding pressure; this
increases the working life of the sanding sheets.
Intensifiying the sanding pressure does not lead to an
increase of the sanding capacity, but to increased wear
of the machine and the sanding sheet.
A sanding sheet that has been used for metal should
not be used for other materials.
Use only original BTI sanding accessories.
2 609 140 341 • 26.9.05
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by an after-sales service centre for BTI
power tools.
In all correspondence and spare parts orders, please
always include the 6-digit order number given on the
nameplate of the machine.
WARNING! Important instructions for connecting
a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to the fol-
lowing code:
Do not connect the blue or brown wire to the earth ter-
minal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it must be
disposed of safely.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
that are no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Subject to change without notice.
English–4
Do not dispose of power tools into
household waste!
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implemen-
tation into national right, power tools