Publicidad
Idiomas disponibles
Idiomas disponibles
Servicing
the Spark Plug
WARNING
Unintentional sparking can result in fire or electric
shock.
Unintentional start-up can result in entanglement,
traumatic amputation, or laceration.
When testing
for spark:
•
Use approved spark plug tester.
•
Do not check for spark with spark plug removed.
CAUTION: Spark plugs have different heat ranges. It is
important that the correct spark plug is used, otherwise,
engine damage can occur.
Clean Spark Plug
Clean with wire brush and sturdy knife. Do NOT use
abrasives (see Figure 13).
Check Spark Plug Gap
Use a spark plug feeler gauge to check the gap between the
two electrodes. When the gap is correct, the gauge will drag
slightly as you pull it through the gap.
If necessary, use the spark plug gauge to adjust the gap by
gently bending the curved electrode without touching the
center electrode or the porcelain.
.030"
(0.76 mm)
install Spark Plug
Finger tighten, then tighten with wrench.
•
180 in-lbs (20 Nm), OR
•
1/2 turn when reinstalling the original spark plug.
1/4 turn when installing a new spark plug.
Figure 13
24
www.snapper.corn
Publicidad
