Snapper 2690978 Manual Del Usuario página 28

Troubleshooting
Troubleshooting the Tractor
PROBLEM LOOKFOR REMEDY
Brake pedal not Fully depress brake pedal.
depressed.
PTO (electric clutch) Place in OFF position.
switch is in ON position.
Cruise control engaged. Move knob to NEUTRAL/OFF position.
Out of fuel. If engine is hot, allow it to cool, then refill the fuel tank.
Fuse is blown. See authorized dealer.
Battery terminals require See Cleaning the Battery and Cables section.
cleaning.
Enginewiii not turnover
i0r start. Battery discharged or Recharge or replace battery.
dead.
Wiring loose or broken. Visually check wiring. If wires are frayed or broken, see authorized
dealer.
Solenoid or starter motor See authorized dealer.
faulty.
Safety interlock switch See authorized dealer.
faulty.
Water in fuel. See authorized dealer.
Gas is old or stale. See authorized dealer.
Fuel mixture too rich. Clean air filter.
Enginestarts hardor runs
j poorly. Engine has other See authorized dealer.
problem.
Low oil level. Check/add oil as required.
Engine knocks.
Using wrong grade oil. See Oil Recommendations Chart.
Engine running too hot. See authorized dealer.
Using wrong grade oil. See Oil Recommendations Chart.
Excessive oil
consumption.
Too much oil in Drain excess oil.
crankcase.
Engine exhaust is black. Dirty air filter. See Servicing the Air Filter section.
Ground speed control Depress pedals.
pedals not depressed.
Transmission release Move into DRIVE position.
Engine runs, but tractor will lever in PUSH position.
not drive.
Parking brake is engaged. Disengage parking brake.
Traction drive belt is See authorized dealer.
broken or slipping.
Brake will not hold. Internal brake worn. See authorized dealer.
Steering linkage is loose, See authorized dealer.
Tractorsteers hard or Improper tire inflation. See Check Tire Pressure section.
i handles poorly. Front wheel spindle See authorized dealer.
bearings dry.
28 www.snapper.com