Publicidad
Idiomas disponibles
Idiomas disponibles
electrical insulation between the power supply voltage
EN
(hazardous) and the parts that are accessible to the user.
2. TECHNICAL SPECIFICATIONS
Power supply
Power consumption
3. PRODUCT DESCRIPTION
1.
Measuring cup
2.
Jar cover
3.
Spout
4.
Glass jar
5.
Blade
4. OPERATING INSTRUCTIONS
4.1. BEFORE FIRST USE
1.
Unpack the appliance and place all parts on a horizontal surface.
2.
Immerse the glass jar (4) and jar cover (2) in warm and soapy water. Rinse and dry
thoroughly.
3.
Do not immerse the housing (7) in water, as this may cause an electric shock.
4.
The blade (5) is very sharp. Be sure to handle it very carefully.
4.2. ASSEMBLING THE TABLE BLENDER
1.
Make sure the power cord is unplugged from the table blender.
2.
Make sure the control knob (8) is in the '0' position.
3.
Place the glass jar (4) directly onto the housing (7) and lock it in place.
Note: The blender will not operate if the glass jar is not assembled properly.
4.3. USING THE BLENDER
1.
Make sure the control knob (8) is in the '0' position.
2.
Connect the table blender to the power supply.
3.
Peel or core the fruits or vegetables and cut them into small pieces.
4.
Transfer the food pieces to the glass jar (4).
5.
Pour a suitable amount of purified water into the glass jar (4) to make sure the blender
can run smoothly. The recommended ratio of food to water is 2:3. Make sure the
mixture does not exceed the maximum marking level indicated on the glass jar (4).
Note: Do not use boiling liquids or run the blender when it is empty. The blender can
also be used for mixing juice and pulp or breaking up ice.
6.
Cover the glass jar (4) with the jar cover (2).
7.
Turn the control knob (8) to the desired speed (P/ 0 / 1 / 2) and start blending.
Tip: For quick blending, hold the control knob (8) in the 'P' position, and then release
it to return to the '0' position to stop the blender. If you set the speed to '1' (low speed)
or '2' (high speed), the blender will stay on until you turn it to the '0' position.
8.
After running the blender for 2 minutes, let it cool down for at least 1 minute before
continuing. Repeat the process until you have finished blending.
9.
Remove the glass jar (4) from the housing (7) by grasping the handle (6) and lifting it
upwards.
10.
Open the jar cover (2) and pour out the food through the spout (3) of the glass jar (4).
220 - 240 V~, 50-60 Hz
500 W
6.
Handle
7.
Housing
8.
Control knob
9.
Base
10. Foot
6
Publicidad
