Declaration Of Conformity; Service; Troubleshooting - Protool SSP 200 EB Manual De Instrucciones Original/Lista De Piezas De Repuesto

14 Declaration of Conformity

We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization doc-
uments:
EN 55 014-1, EN 55 014-2, EN 60 745-1,
EN 60 745-2-13, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the regula-
tions stipulated in Directive 98/37/EC (until
28 Dec. 2009), 2006/42/EC (from 29 Dec.
2009), 2004/108/EC, 2000/14/EC.

15 Service

Any repairs during and after the warranty period shall be performed by the service cen-
tres listed.

15.1 Troubleshooting

Problem
The machine will not run
The cut is not clean; the
chain goes to the side
Strong force required to
move the machine into
the cut:
The chain is not lubri-
cated:
34
Cause
No power supply
Worn brushes
Stuck switch
When overloaded
Moves into cut too far
Blunt tool
The chain is not sharpened
properly
The supporting area of the
runner is dirty
Blunt tool
Different qualities of wood
Moves into cut too far
Blocked lubrication grooves
on the guide bar
Defective oil feed pump
Empty oil reservoir
The machine's inner oil chan-
nels are clogged or the bio oil
has solidifi ed
09
Manfred Kirchner
Research and
development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
1. 3. 2009
Solution
Check the safety fuses and
the power cords
Replace the brushes
Press the unblocking button
Check the safety fuses
Reduce the movement
Sharpen the chain or
replace it with a new one
Replace the chain with a
new one
Clean it
Sharpen the chain or
replace it with a new one
Adjust the size of the
movement into the cut
Reduce the movement
Clean the guide bar
Replace the pump (at an
authorised service centre)
Replenish chain oil
Clean the machine (at an
authorised service centre)