Diamond D701/8P Manual De Instrucciones página 11

UK

Press ON/OFF (1), on the DISPLAY (4) the central segments will light up, indicating that the
machine is powered.
I
n machines fitted with water softener, when the warning 'SA Lt' appears you should add salt to the
relative container; proceed as follows:

Remove the basket from the machine.

Remove the integral filter ( Fig. 7 ).

Unscrew the cap on the salt container ( Fig. 11 ).

Pour in approx. 700g of large-grain kitchen salt, using the funnel supplied. (when filling for the first
time, fill the tank firstly with water)

Close the container firmly.

Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of
corrosion.

The 'SA Lt' warning will disappear after a few minutes.
The warning rE G on the display indicates that the machine is running a resin regeneration cycle,
needed to ensure the correct operation of the water softener; while this warning is shown, the cycles
run could be longer than usual.
N.B. Do not switch off the machine if a regeneration cycle is underway
With the machine on, hold the PROGRAMME SELECTION button (2) down for five seconds until "CC"
appears, followed by the number of wash cycles carried out during the machine life.
Door open

At the end of the day always drain the machine as described in the section Machine draining.

Disconnect the power supply by means of the main switch and close the external water cock.

Perform routine maintenance and clean the machine as described in the section Maintenance.

If possible, leave the door ajar to prevent bad odours building up inside the machine.
Page 8 of 12
INSTRUCTION MANUAL FOR DISHWASHERS
4.8 Turning the dishwasher off
4.9 Resin regeneration (*optional)
4.10 Displaying information
4.11 List of viewable messages
Number of cycles carried out
4.12 End of shift