Bosch GRW 18-2 E Professional Manual Original página 11

Stirring mechanism
– 2nd gear
Rated torque
– 1st gear
– 2nd gear
Tool holder
Maximum stirrer paddle diameter
Weight according to
EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/vibration information
Noise emission values determined according to EN 62841-2-10.
Typically, the A-weighted noise level of the power tool is
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to EN 62841-2-10:
h
a
h
K
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
and organising workflows correctly.
Assembly
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Bosch Power Tools
-1
min
Nm
Nm
mm
kg
dB(A)
dB(A)
dB
2
m/s
2
m/s
Changing the Tool
Stirrer paddle with M14 male thread
Screw the stirrer paddle (5) into the drive spindle (4). To do
this, hold the drive spindle (4) using an open-ended spanner
(GRW12 E: Width across flats 22 mm, GRW18-2 E: Width
across flats 24 mm) and use a second open-ended spanner
(width across flats 22 mm or 24 mm) to tighten the stirrer
paddle (5).
The stirrer paddle is disassembled in reverse order.
English | 11
GRW 12 E GRW 18-2 E
–
12
–
M14
140
5.3
/ II
GRW 12 E GRW 18-2 E
91
102
3
3.0
1.5
(4)
(5)
1 609 92A 5AE | (10.09.2020)
0–580
45
19
M14
180
7,2
/ II
91
102
3
3.5
1.5