Craftmade WHS42FBGW3 Instrucciones De Montaje página 6

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin and
clip. Lower hanging ball and remove stop pin. Then
slide hanging ball off downrod. [Refer to diagram 1.]
Remove vice from safety cable by loosening the
screw and nut on the vice. Loosen yoke set screws
and nuts at top of motor housing.
2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [Refer to
diagram 2.]
Thread downrod into the motor assembly yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nut securely. [Refer to diagram 2.]
Slide yoke cover, canopy cover, and canopy over
downrod. [Refer to diagram 3.] (Note: Canopy cover
must be turned with smooth side toward motor
assembly.)
Thread wires and safety cable through hanging ball
and then slide hanging ball over downrod -- the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise hanging
ball. Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely. [Refer to
diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
NOTE: Do not tamper with blades. When motor
begins to rotate, the blades will automatically unfold
and extend to rotate.
["Fan Assembly" continued on next page.]
diagram 1
[Refer to diagram
diagram 2
diagram 3
diagram 4
page 6
set screw
clip
nut
vice
screw
safety cable
electrical wiring
downrod
clip
downrod
canopy
yoke cover
stop pin
stop pin
hanging ball
pin
yoke set
screw
and nut
pin
motor
assembly
safety cable
canopy cover
motor
assembly
set screw hole
hanging
ball
canopy