Craftmade WHS42FBGW3 Instrucciones De Montaje página 8

6. Wiring.
WARNING: Turn off circuit breakers to
current fixture from breaker panel and be
sure switch is turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred to
in the diagram to the right, please use a
qualified electrician.
Note: Excess lead wire length from the fan can
be cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with
wire connectors provided as shown in
diagram at right.
Tip: While you are wiring, keep in mind that wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket and carefully push wires and
taped wire connectors into outlet box. Let antenna rest outside of hanging bracket.
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
ground (green
or bare)
white
red
black
yellow
gray
from fan
from
receiver
gray
yellow
blue
red
white
screw
canopy
page 8
white supply wire
black supply wire
ground (green/bare)
ground
(green)
white
black
from
ceiling
antenna
from
receiver
ground
(green/yellow)
black AC IN L
white AC IN N
receiver
antenna
hanging bracket
screw
canopy cover
*