Craftmade WHS42FBGW3 Instrucciones De Montaje página 7

5. Fan Assembly. (cont.)
With the hanging bracket secured to the
outlet box and able to support the fan,
you are now ready to hang your fan.
Grab the fan firmly with two hands.
Slide downrod through opening in
hanging bracket and let hanging ball
rest on the hanging bracket. Turn the
hanging ball slot until it lines up with
the hanging bracket tab.
WARNING: Failure to align slot in
hanging ball with tab in hanging
bracket may result in serious injury or
death.
NOTE: The important safety precautions
and instructions appearing in the manual
are not meant to cover all possible
conditions and situations that may occur.
It must be understood that common sense
and caution are necessary factors in the
installation and operation of this fan.
Find a secure attachment point (wood
ceiling joist highly recommended) and
secure safety cable. It will be necessary
to use a heavy duty wood screw, washer
and lock washer (not supplied) with the
safety cable loop.
Replace vice on safety cable and adjust
safety cable length by pulling on the
cable. Adjust slack in cable to a hands
length and secure vice by tightening
screw and nut securely. The loop at the
end of the safety cable should just fit
over the threads on the wood screw.
[Refer to drawing at right.] Test safety
cable by pulling on loose end of the cable
with pliers. If the safety cable slips, the
screw and nut on the vice must be set
tighter. Extra cable slack can be left in
ceiling area.
wood
ceiling
joist
page 7
safety cable loop
wood screw
and washer
screw
nut
safety cable
hanging bracket tab
hanging ball slot
motor
assembly