Truper MOT-3814 Instructivo página 43

Adjustments and
maintenance
Air Filter Cleansing
• Set the chain brake.
• Then pull the choke lever completely outwards to
prevent contaminating the carburetor during the cleaning
process.
• When removing the air filter use compressed air or a
brush in the uncovered area to eliminate soil and sawdust
as much as possible.
• Reliant on the use time, clean the filter superficially only
tapping it against a smooth and flat surface to dislodge
most of the sawdust and dust particles.
• The air filter can also be cleaned with compressed air.
Clean on both sides.
• For a more complete cleansing wash the air filter with a
soapy solution, rinse and let dry completely before
installing back in the chain saw.
• If using compressed air to dry it, blow air on both sides
of the filter.
• Lubricate the air filter with several drops of chain oil to
improve filtration.
• Set back the air filter. Verify it matches and rests perfectly
in the base before tightening the screw.
General Cleaning
• Using a brush or compressed air clean and clear the
ventilation slots in the starter unit each time is necessary.
• Likewise, clean periodically the blades in the motor
cylinder and the ventilator blades to remove dirt.
Otherwise the motor can get damaged due to
overheating.
• Depending on the type of fuel and oil used, or the
particular functioning conditions, the exhaust orifice and
the muffler can be obstructed with coal deposits. If the
chain saw shows loss of power it will be necessary to
eliminate such deposits to restore performance. Take the
chain saw to a
Center to carry out this service.
Fuel Filter
• Check periodically the fuel filter. If contaminated or
damaged, go to a
Center to replace it.
Authorized Service
Authorized Service
WARNING
• Never try to start the motor
WITHOUT assembling first all the chain saw parts.
Otherwise the parts can get fractured and shoot out
towards the operator. Can also damage the chain saw and
make the Warranty void.
19
ENGLISH