Brizo MultiChoice T75P6 Serie Manual Del Usuario página 6

4
3
1
Trim Sleeve Installation
Insert Spacer (3) into the sleeve (1) and push it to
the front. Slide trim sleeve (1) over the bonnet (2),
valve cartridge and rough-in body.
Ensure sleeve is properly positioned over the front
of cartridge.
Cylinder trim sleeve (4) does not require a spacer.
Ensure the word FRONT points out and slide trim
sleeve all the way on over the cartridge.
6
Handle Installation
A.
1
Valve Handle Installation
Using a hex wrench, install valve handle (1)
with screw (2). Applying pressure, insert button
if provided (3) until properly seated.
106855 Rev. B
2
4
2
3
5
4
5
Escutcheon Installation
For finished wall thickness up to 1 1/8". Secure
the backplate (1) to the rough-in body (2) using 4
screws (3) provided.
Note: Be sure backplate is oriented front side
forward and markings are visible.
Push seal (6) onto back on escutcheon (4) valve
hole. Slide escutcheon (4) over valve and diverter
cartridges, thread trim nut (5) provided onto diverter
sleeve.
Note: For thick wall installations, order
installation kit RP100160 to support finished
wall thickness up to 2 1/8".
On rough or uneven surfaces it is necessary to
apply caulk around the backplate (1) to supplement
the seal. Do not caulk the drip notch in the bottom
of the backplate (1). Do not caulk the escutcheon
(4).
B.
Models with axial screw in handle blade -
Secure handle onto the stem using screw and hex
wrench or screwdriver as needed. Insert button
into handle.
6
2
1
3
3
6