Publicidad
Idiomas disponibles
Idiomas disponibles
3
A.
Optional Extension
Kit Available
C.
6
Slide O-ring (1) over cartridge and the
A.
bonnet nut (2). The O-ring,
which acts as a spacer to steady the sleeve,
should rest behind the
bonnet nut. Note: Depending on the
location of valve within the wall and
wall thickness, an optional extension kit
can provide an additional 1 3/4" of wall
thickness. To reference replacement parts
visit www.brizo.com.
If your model requires a spacer (3), install
B.
it into sleeve (4). Slide the sleeve over the
cartridge, body and O-ring. Ensure sleeve
is properly positioned over the front of
cartridge.
C.
Secure the escutcheon (5) to the rough
(2) with the 2 screws provided (6). Do not
overtighten escutcheon screws.
D.
D1: Handle with Axial Screw
Remove the top button (7) from the handle
(if already assembled) by pulling straight up.
Select legacy models have a plastic insert
(8) inside the bottom of the handle. For those
models, verify plastic insert is inside the
handle.
106854 Rev. B
1
2
5
B.
2
D.
7
8
Make sure valve is in the full cold position (to the
right) and align lever of lever handle models to
the cold position on the escutcheon and press
handle onto valve stem. Secure handle with
screw provided and press button back into top
of handle.
D2: Handle with Side Screw
Select legacy models have a plastic insert
(8) inside the bottom of the handle. For those
models, verify the plastic insert is inside the
handle. Make sure valve is in the full cold
position and align lever of lever handle models
to the cold position on the escutcheon and
press handle onto valve stem. Secure handle
with set screw provided and install set screw
cover (if included).
D3: Handle with Stem Extender
Install stem extender (9) onto valve stem and
secure with screw (10). Slide handle onto stem
extender and tighten set screw (11). Insert
button (12) until properly seated
7
3
4
D1
D2
D3
9
10
11
12
Publicidad
