Grundig 01M-GSS1100-4320-01 Manual Del Usuario página 37

WI-FI NETWORK-FIRST INSTALLATION ___________
• You can also choose to keep the network
connected by using the "Keep network
connected" option in the network settings menu.
• In the standby mode, the Wi-Fi signal indicator
is displayed with or without a cross through it
according to the chosen network settings.
• You will then need to set "Keep network
connected"option.
• Choose < YES > to activate this function (if you
will use the UNDOK app for remote control) or
choose < NO > to deactivate this function.
• The Soundbar will then start scanning for
available Wi-Fi networks.
• Display: < Network wizard Scanning / > will
appear. After completed
• Display: < SSID > list will appear for selection.
• After network wizard scan is completed, the
name of your wireless network (SSID) will appear
on the screen together with all other available
networks (SSID List).
• Highlight the name of your wireless network in
the SSID list by scrolling up or down and go to
the next steps to make required inputs.
Note:
• If your Wi-Fi network is not found in SSID list;
-then device may be too far from your Wi-Fi router.
Or;
-you may need to switch on your wireless router
(please see the instructions supplied with it).Or;
-it may be because the router is configured not
to broadcast the SSID. You should then select the
< Manual config > option in order to enter the
network details manually.
>
-If your network name is being broadcast, and it
was not found, then try selecting the < Rescan>
option to scan again or try moving your Soundbar
closer to your Wi-Fi router.
WPS (Optional)
Note:
• WPS (Wi-Fi Protected Setup) encrypted networks
are identified by "[WPS]" shown in front of the
SSID, and have two methods of connection.
Select one and follow the prompts. When using
the Network wizard an additional option < Skip
WPS > is available.
< Push Button >
• If you select this option, the Soundbar prompts
you to press the connect button on the router
and then press the [ ] button.
< PIN >
• If you select the option < PIN >, the Soundbar
generates an 8-digit code number which you
should enter into the wireless router using
a web browser (refer to your router's user
documentation). You should then press the[ ]
button.
< Skip WPS>
• Select < Skip WPS > to skip WPS setup and
go directly to the < Key > menu to enter the
network password when your Wi-Fi router is
a standard encrypted network that does not
support WPS.
Key (Password)
• After your Wi-Fi network is found by the device,
the »Password entry« screen will appear.
• if your network is using one of the encryption
systems: WEP, WPA/WPA2. You will need to enter
the correct encryption key (password) into the
ENGLISH 37