UNITED OFFICE UAV 190 C2 Instrucciones De Uso página 10

Operation
Note
ATTENTON!
Using auto mode
♦ Set the switch
green. The motor starts automatically as soon you insert paper and switches
off automatically once no further paper is inserted.
Note
► Always insert smaller pieces of paper into the middle of the cutter opening
This is where the contact that starts the cutting process is located.
► If the appliance overheats, the overheat LED
touches the contact which starts the cutting process. The appliance will not start
cutting. Proceed as described in the section Note regarding overheating of
the appliance.
Clearing a material blockage
♦ Move the switch
shredded causes a blockage.
The appliance now goes into reverse and the paper that is being shredded
is ejected.
♦ Pull the paper out of the appliance, then set the switch
♦ The appliance is now ready for use.
Note
► Reverse mode is solely for clearing paper jams. Do not use it for removing
documents that are already half shredded and are not causing a jam.
UAV 190 C2
You can shred up to 6 sheets (80 g /m
Remove all paper clips or staples before inserting the paper into the
2
cutter opening
1
to the AUTO for shredding. The power LED
1
to the REV ("reverse") position if the paper being
2 paper) at the same time.
. The cutting blades might otherwise be damaged.
4
lights up as soon as the paper
3
lights up
2
.
1
to AUTO.
GB │ IE
│
7 ■