SOMFY SONESSE2 28 Zigbee Manual De Instrucciones página 16

Idiomas disponibles

3.4.Replacing the battery

NOTICE

Somfy recommends replacing the battery with the same type referenced available in

the Somfy catalog. Using another type of battery could result in system damage and

voiding of the warranty.

PRECAUTION

Replacement of the battery only must be carried out by a motorisation and home

automation professional.

CAUTION

• Do not use tools that could damage the drive when replacing the battery.

• Do not cut or damage the antenna cable.

1] If the drive is fixed to the tube, disassemble the motorised product to access

the self-tapping screws or steel pop rivets (drive wheel side) and remove

them.

2] Grab the motor head and pull out the drive by sliding it out of the motorised

product tube.

3] If necessary, offset the ring gear on the actuator tube to access the cruciform

screws and unscrew the motor head.

4] Remove carefully the motor head from the tube taking care not to damage

the wires and disconnect the battery.

5] Grab and remove the used battery using the hook tool available in the Somfy

catalog or supplied with the battery pack, by sliding it out of the tube taking

care not to damage the wires.

6] Insert and slide the new battery into the drive tube, leaving the battery

connector accessible from the outside of the tube.

7] Connect the new battery.

8] Insert the motor head using the keying notches on the drive tube taking care

not to cut off the wires.

9] Screw the motor head using the cruciform screws to the drive tube.

➔ Restart the installation referring to Assembly chapter.

NOTICE

if necessary, readjust the end limits.

SONESSE2 28 Zigbee LI-ION