Switching An Element Off; Dual Element Activation; Triple Element Activation; Bridge Element Activation - Fulgor Milano F6RT24 Serie Manual De Uso & Mantenimiento

The control uses only the 15% of the available power,
divided in 0 to 9 steps with a better accuracy.
Keep in mind that power level 9 in this special mode
correspond exactly to level 4 in the standard range.
in order to disable the Low Power Scale and restore the
standard one, without switching off the zone.
Pay attention: the level remains the same but the
power increases.
Switching off a cooking zone as described below
disables the Low Power mode. When the zone will be
selected again it will start to work in the standard power
mode.
heating element.
You may turn off all active elements at the same time by
outer ring of a double zone. This operation is possible
The dual element enabling indication (ref.5a) is on
when the element is enabled, is off when the element
is disabled.
outer rings of a triple zone:
• If only the inner element is enabled, the intermediate
ring is enabled too.
• If the inner and the intermediate elements are
enabled, the outer ring is enabled too.
• If all the elements are enabled, the outer and the
intermediate rings are disabled.
These operations are possible until the HOT SURFACE
The intermediate element enabling indication (ref.5a) is
on when the double element is enabled, is off when the
double element is disabled.
The outer element enabling indication (ref.5b) is on
when the triple element is enabled, is off when the triple
element is disabled.
Select one of the two single heating areas belonging
element and set the whole cooking area as a single
unit.
This operation is possible until the HOT SURFACE led
level:
• Set the power level on the selected zone then touch
same power level and both extension lights (ref.1a,
1b) turns on.
(ref.6a, 6b) turns on. Set the power level that will be
immediately and simultaneously displayed on both
displays.
6b
6a
Figure. 9
used indifferently to control the bridge area. All actions
will have the same effect on the whole cooking area.
active. It's always necessary to switch the area off: the
bridge will be disabled automatically.
Each element has a HOT SURFACE indicator light
(ref.3) to show when the cooking area is hot.
This indication turns on when the zone is activated and
remains ON until the cooking area has cooled down to
Use & Care Manual
ENGLISH
3
3
11