Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Install Tank (A), (Figure 5)
• Place rubber washer (II) onto bolt (JJ). Insert bolt (JJ)
with washer through hole inside the tank (A).
• Place metal washer (HH) followed by hex nut (KK) onto
bolt (JJ) protruding from bottom of tank (A). Tighten
hex nut (KK) to create a proper and secure seal.
• Attach rubber sealing gasket (LL) to center drain hole
under tank (A).
• Gently place tank (A) on toilet bowl (B) with bolts (JJ)
protruding out underneath.
• Place metal washer (HH) followed by hex nut (KK)
onto the protruding bolt (JJ).
• Tighten hex nut (KK) enough so that the tank (A) sits
flat on the toilet bowl (B).
• Make sure the toilet tank (A) is parallel to the wall and
straight on the toilet bowl (B).
• CAUTION: DO NOT OVERTIGHTEN NUTS. SEVERE
DAMAGE MAY OCCUR.
7. Install Tank Lever Handle Assembly (D), (Figure 6)
• Turn clockwise to remove plastic nut
(pre-assembled) from the lever arm.
• Insert lever arm throught the hole on the left side
of the tank. Screw the plastic nut (pre-assembled)
counterclockwise to tighten it.
• Hook the chain onto the lever. With the lever at
rest the chain should only be long enough for
flapper to close.
Exclusively Distributed By:
HD Supply Facilities Maintenance, Ltd.
Atlanta, GA 30339
© 2022
Made in China
Figure 5
Figure 6
D
A
To Reorder:
1-800-431-3000
hdsupplysolutions.com
5
Publicidad
