Descargar Imprimir esta página

Craftsman SPEED START INCREDI-PULL 316.791770 Manual Del Operador página 16

Ocultar thumbs Ver también para SPEED START INCREDI-PULL 316.791770:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
To avoid serious personal injury, always stop
the engine and allow it to cool before cleaning or maintaining
the unit. Never perform cleaning or maintenance while the
unit is running. Disconnect
the spark plug wire to prevent
the unit from starting accidentally.
_
ARNING:
Wear protective clothing and observe all
safety instructions to prevent serious personal injury.
MAINTENANCE
SCHEDULE
Perform these required maintenance
procedures at the frequency
stated in the table. These procedures should also be a part of any
seasonal tune-up.
NOTE: Some maintenance procedures may require special tools or
skills. If unsure about these procedures, take the unit to a Sears
or other qualified service dealer. Call 1-888-331-4569
for more
information.
NOTE: Maintenance, replacement,
or repair of the emission control
devices and system may be performed by a Sears or other qualified
service dealer. Call 1-888-331-4569
for more information.
NOTE: Please read the California/EPA statement that came with the
unit for a complete listing of terms and coverage for the
emissions control devices, such as the spark arrestor, muffler,
carburetor, etc.
FREQUENCY
MAINTENANCE
REQUIRED
Every 10 hours
Clean and re-oil the air filter. Refer to
(every 5 hours
Maintaining the Air Filter.
in vacuum
mode)
Every 25 hours
Check the spark plug condition and gap.
Refer to Maintaining the Spark Plug.
MAiNTAiNING
THE AIR FILTER
Failure to maintain the air filter can result in poor performance or can
cause permanent damage to the engine. Engine failure due to
improper air filter maintenance is not covered by the product warranty.
Cleaning
the Air Filter
1. Open the air filter cover: press in the lock tab and swing the air
filter cover to the left (Fig. 18).
2. Remove the air filter (Fig. 18).
3. Wash the air filter in detergent and water. Rinse the air filter
thoroughly
and allow it to dry.
4. Lightly coat the air filter with clean SAE 30 oil.
5. Squeeze the air filter to spread and remove excess oil.
6. Reinstall the air filter (Fig. 18).
NOTE: Operating the unit without the air filter and air filter cover will
VOiD the warranty.
7. Close the air filter cover: insert the tabs on the air filter cover into
the slots on the backplate. Swing the air filter cover to the right
and press it closed until the lock tab snaps into place (Fig. 18).
Tabs
Lock Tab
Air Filter Cover
Fig. 18
Backplate
Air Filter
16

Publicidad

loading