Publicidad
Idiomas disponibles
Idiomas disponibles
8.2
Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the leaf blower is
switched off or remove the battery pack.
▪
Hold the tool with one hand and the battery pack (13) with the other.
▪
To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪
To remove: Press the battery release latch and pull the battery pack out at the same time.
8.3
Battery capacity indicator (Fig. 3)
There are battery capacity indicators (16) on the battery pack, you can check the capacity
status of the battery if you squeeze the button (15). Before using the machine, please press
switch trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED's are lit: Battery fully charged.
2 LED's are lit: Battery 60% charged.
1 LED is lit: Battery almost discharged.
9 ASSEMBLY
WARNING: Switch off and remove battery from machine before adjusting or
cleaning!
WARNING: Always wear shoulder strap when operating machine.
9.1
Assembly of the tubes (Fig. 4)
▪
Insert the upper suction tube (2) into the cordless leaf blower body ensuring that it fits
correctly and is pushed fully in.
▪
Secure it on both sides of the suction/blower housing with the two 12 mm screws
provided.
▪
then Insert the upper blowing tube (3) into the cordless leaf blower body ensuring that it
fits correctly and is pushed fully in.
▪
Secure it with the 18 mm screw provided.
▪
Insert both upper suction (2) & upper blower tube (3) into the lower suction/blower tube
(1).
▪
Ensure that it is fitted correctly and pushed fully in.
▪
Secure both with the two 18 mm screws provided.
9.2
Fixing the wheels
▪
Slide the wheel set onto the lower tube of the leaf blower as shown in Fig. 5.
▪
Place the wheels in the desired position and fasten them with the handle screw (Fig. 6).
9.3
Fitting the adjustable handle
▪
Connect the adjustable handle to into the cordless leaf blower body (Fig. 7).
▪
Adjust the handle position at wish.
▪
tighten the knob screw (Fig. 8).
Copyright © 2024 VARO
POWDPG75270
P a g e
| 8
EN
www.varo.com
Publicidad
