Publicidad
Idiomas disponibles
Idiomas disponibles
Removing a blockage (Fig. 18 – Fig. 19)
10.6
Your 40 V cordless leaf blower is equipped with a cleaning window flap (11).
When the impeller becomes blocked it can be accessed for cleaning.
Open the window flap by loosening the screw knob to remove any debris.
Note: For safety reasons the machine has a built-in safety switch that
prohibits the machine from working when the cleaning flap (11) is not
correctly and fully closed. Make sure to close the cleaning window flap (11)
well before resuming work.
10.7
Working with the blowing function
Note: Any hard objects, such as stones, tin cans glass, etc, will be thrown
away.
Inspect the area to be worked before starting. Remove any objects or debris that could be
thrown by the cordless leaf blower.
Select the blow function using the selector lever (8) on the side of the machine and switch the
machine on. With the cordless leaf blower resting on its wheels move the cordless leaf blower
forwards directing the nozzle at the debris to be cleared.
Alternatively hold nozzle just above the ground and swing the machine from side to side,
moving forwards and directing the nozzle at the debris to be cleared. Blow the debris into a
convenient heap, then use the vacuum function to collect the debris.
10.8
Working with the vacuum
Inspect the area to be worked before starting. Remove any objects or debris that could jam or
become entangled in the cordless leaf blower. Select the vacuum function using the selector
lever (8) on the side of the machine and switch the machine on.
With the cordless leaf blower resting on its wheels move the cordless leaf blower forwards
directing the nozzle at the debris to be collected.
Alternatively, with the cordless leaf blower held just above the ground swing the machine from
side to side, moving forwards and directing the nozzle at the debris to be collected.
Note: Do not force the nozzle into the debris as this will block the suction
tube and reduce the efficiency of the machine.
Organic materials such as leaves contain a large amount of water that can
cause them to stick to the inside of the suction tube.
To reduce sticking the material should be left for a few days to dry out.
▪
When using the Vacuum Blower in suction mode the debris is sucked up the suction tube
before being ejected into the collection bag (9).
▪
The suction fan is equipped with a knife, increasing the shredding capacity significantly.
▪
As the debris passes through the suction fan, it will be shredded.
▪
The shredded organic debris is ideal to use as mulch around plants.
Copyright © 2024 VARO
POWDPG75270
P a g e
| 10
EN
www.varo.com
Publicidad
