Duratech DT105038A Manual De Seguridad Y Operacion página 16

12. Charger Indicator
Indicator Status
Red LED Green LED
ON OFF
Blink OFF
ON Blink
OFF ON
Blink Blink
Blink OFF
GB
Explanations and Actions
Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger
Pre-charge Mode (low-current safety charging)
As the battery pack voltage is under 12.5V,the charger is in Pre-charge
mode.the charging current is below 0.5A.This can maximum the life of the
battery.
High-current charging
As the battery pack voltage is above 12.5V,the charger is in quick charge
mode.the charging current is at 2.3-2.4A.
Important ! The actual charging times may vary slightly from the stated
charging times depending on the existing battery charge.
The battery is charged and ready for use.
The battery is fully charged and ready to use..
Action: Take the battery pack out of the charger. Disconnect the charger from
the mains supply.
Fault
Charging is no longer possible. The battery pack maybe defective.
Action:
Never charge a defective battery pack.Take the battery pack out of the charger.
Temperature fault
The battery pack is too hot (e.g. due to direct sunshine/prolonged use) or too
cold (below 40°F/4°C).
Action: Remove the battery pack and keep it at room temperature (approx.
68°F / 20°C)for3Hours.
16