THE MOON PHASE ICONS
The weather station displays 8 different moon phase icons. The current moon phase is indicated with a bar
segment according to the set calendar.
Waxing
First
Quarter
Crescent
LOW BATTERY INDICATORS
Low battery indicator will show on the LCD when the batteries of weather station or transmitter require changing.
THERMO-HYGRO TRANSMITTER
The reception distance of the thermo-hygro transmitter may be affected by the temperature. At cold temperatures
the transmitting distance may be decreased. Please bear this in mind when placing the transmitter.
868 MHz RECEPTION
The weather station should receive the temperature data within 2 minutes after set-up. If the temperature data is
not received 2 minutes after setting up (the outdoor temperature shows " --.- "), please check the following points:
1.
The distance of the weather station or transmitter should be at least 1.5 to 2 meters away from any
interfering sources such as computer monitors or TV sets.
2.
Avoid positioning the weather station onto or in the immediate proximity of metal window frames.
3.
Using other electrical products such as headphones or speakers operating on the same signal frequency
(868 MHz) may prevent correct signal transmission and reception.
4.
Neighbors using electrical devices operating on the 868 MHz signal frequency can also cause
interference.
Note:
When the 868 MHz signal is received correctly, do not re-open the battery cover of either the transmitter or
weather station, as the batteries may spring free from the contacts and force a false reset. Should this happen
accidentally then reset all units (see "Setting up") otherwise transmission problems may occur.
The transmission range is about 100 m from the transmitter to the weather station (in open space). However, this
depends on the surrounding environment and interference levels. If no reception is possible despite the
observation of these factors, all system units have to be reset (see "Setting up").
POSITIONING THE WEATHER STATION:
The weather station comes complete with a foldout stand that gives the option of table standing or wall mounting.
wall mounting, please check that the outdoor data can be received from the desired locations.
To wall mount:
1.
Fix a screw (not supplied) into the desired wall, leaving the head extended out by about
5mm.
2.
Place the weather station onto the screw, using the hanging hole on the backside. Gently
pull the weather station down to lock the screw into place.
Waxing
Full
Waning
Last
Gibbous
Moon
Gibbous
Quarter
A bar segment indicates the
current moon phase
Waning
New
Crescent
Moon
27
Before