Care And Maintenance - La Crosse Technology 53147130 Manual De Instrucciones

Foldout table stand:
The foldout table stand leg is located on the backside. Pull the stand out from the bottom
center edge of the weather station, below the battery compartment. Once the foldout
table stand is extended, place the weather station in an appropriate location.
POSITIONING THE THERMO-HYGRO TRANSMITTER:
The thermo-hygro transmitter can be placed onto any at surface or wall mount using the bracket
which doubles as a stand or wall mount base.
Mounting at a sheltered place. Avoid direct rain and sunshine.
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
Note: Before permanently xing the thermo-hygro to the wall base, place all units in the desired
locations to check that the outdoor temperature and humidity readings are receivable. In event that
the signal is not received, relocate the units or move them slightly as this may help the signal
reception.

CARE AND MAINTENANCE:

Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and
give inaccurate forecasts and readings.
When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents
as they may mark the LCD and casings.
Do not submerge the unit in water.
Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new
batteries of the recommended type.
Do not make any repair attempts to the unit. Return them to their original point of purchase for repair by a
quali ed engineer. Opening and tampering with the unit may invalidate their guarantee.
Do not expose the units to extreme and sudden temperature changes, this may lead to rapid changes in
forecasts and readings and thereby reduce their accuracy.
28