Descargar Imprimir esta página

DS18 SDX-P200 Manual De Usuario página 11

Receptor de medios digitales din único con dsp

Publicidad

REPLACING REMOTE BATTERY /
Remove the battery protector (CR-2O25).
The remote control is suppliedwith battery
protection. The remote control will not
operate unless the protection is removed.
Replacing the battery:
When the lithium battery has lost capacity,
replace it as shown in the illustration.
1.Pull the cell holder from the remote control
in the direction of arrow 1.
2.Replace the old battery with a new one.
Observe the polarity! Make sure the (+) is
at the top!
3.Insert the battery holder into the remote
control.
Retire el protector de la batería (CR-2O25). El
control remoto se suministra con protección de
batería. El control remoto no funcionará a menos
que se elimine la protección.
Sustitución de la batería:
Cuando la batería de litio haya perdido capacidad,
reemplácela como se muestra en la ilustración.
1. Tire del portaceldas del control remoto en la
dirección de la flecha 1.
2. Reemplace la batería vieja por una nueva.
¡Observe la polaridad! ¡Asegúrate de que el (+)
esté en la parte superior!
3. Inserte el portabaterías en el control remoto.
BASIC OPERATION /
Press any button to switch the unit on.
Press and hold button (1) / SRC to switch
off. Turn the volume knob to set the desired
level. Press button (1)
between playback sources: Radio -->
USB --> AUX in --> Bluetooth.
REEMPLAZO DE LA BATERÍA
OPERACIÓN BÁSICA
/ SRC to switch
Pulse cualquier botón para encender la unidad.
Mantenga presionado el botón (1)
apagar. Gire la perilla de volumen para establecer
el nivel deseado. Presione el botón (1)
para cambiar entre las fuentes de reproducción:
Radio -->USB --> Entrada AUX --> Bluetooth.
1
2
3
/ SRC para
/ SRC
10

Publicidad

loading