Publicidad
Idiomas disponibles
Idiomas disponibles
Engine maintenance
Clean the cooling fins of the engine.
Replace the engine oil.
Replace the air filter.
Do a check of the engine speed.
Examine and clean the spark plug. Replace the spark
plug if it is necessary.
Clean the spark arrester screen on the muffler.
Adjust the valve head clearance for the air intake and the
exhaust valves.
Drain the fuel and clean the fuel tank and the fuel filter.
Drain water from the fuel system.
Replace the fuel filter.
To clean the product
CAUTION:
product, attach a plastic bag tightly around
the fuel tank cap. This is to make sure that
water does not go into the venthole in the
fuel tank cap.
•
Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION:
directly at the fuel tank cap, electrical
components or the engine.
•
Remove grease and oil from the handle.
To do a general inspection
•
Make sure that all nuts and screws on the product
are tightened correctly.
To do a check of the engine oil level
1. Put the product in an upright position.
2. Remove the oil tank cap and dipstick.
2424 - 002 - 18.04.2024
Before you clean the
Do not point the water
Before use,
After the
each 10 h
first 20 h
O
X
X
O
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 16 for the correct type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Put a container below the drain plug for the engine
oil.
Weekly,
Yearly, each
each 100 h
300 h
X
X
X
X
O
O
O
O
O
O
O
O
O
O
Technical data
Engine oil is very hot
11
Publicidad
