Patron TA 55 Manual Del Usuario página 9

To start the product
1. Set the throttle control in the start position.
2. If the engine is cold, push the primer bulb 5 times.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
4. Pull the starter rope handle slowly until you feel
resistance.
5. Release the starter rope handle to let the starter
rope go back.
6. Pull the starter rope handle until the engine starts.
2424 - 002 - 18.04.2024
7. Open the choke control gradually until it is fully open.
8. Let the engine operate at idle speed for 2–3 minutes
before you apply full throttle.
To operate the product
1. Set the throttle control in the operation position.
2. Hold the handle and move the product in the
necessary direction.
CAUTION:
down. Too much pressure can cause
unsatisfactory result.
3. Make sure that the rammer shoe is parallel to the
ground during the operation.
Do not push the product
9