Publicidad
Idiomas disponibles
Idiomas disponibles
SFA 7600
MOUNTING
1. Open the package and take out the products, make sure all components are included, manual,
remote control, etc.
2. Place the humidifier body (12) on the base (9) and fix it from below with the fixing screw (10).
3. Then place the fan head (1) on the humidifier and fix it with the small fixing screw (4) at the back
and the fixing clip at the front (13).
4. The fan with humidifier will be completely assembled..
REMOTE CONTROL
Works with 1 CR 2025 battery.
Slide the cover to open the battery compartment on the back of the remote control.
Place the battery into the slot, with the positive and negative facing the correct direction.
Install the rear cover.
The battery contains materials that are harmful to the environment and must be recycled
properly.
FILLING THE WATER TANK
Open the water tank door (5).
Remove the water tank from the fan body (6).
Unscrew the cap at the bottom (7).
Fill it with water and screw the cap back on.
Put the tank back in its place and close the retaining door (5)
INSTRUCTIONS FOR USE
Connect the power plug of the appliance to the power source.
Press the On/Off button on the control panel to turn on the device.
By pressing the fan speed button, you can choose between 4 speeds (very low, low, medium,
high) which illuminate the corresponding indicator lights on the LED display.
Press the timer button to set the timer between 0.5 and 7.5 hours.
When the set time expires, the device will turn off automatically.
By pressing the oscillation button, the fan head will rotate from left to right continuously, until
the button is pressed again.
Press the turbo mode button to activate this mode; Press the fan speed button to turn it off.
Before using:
Ensure packaging has been removed from all products.
Use:
CAUTION: Care must be taken to avoid spills when moving the appliance.
Extend the cable completely before plugging it in.
Connect the device to the electrical network.
Angle the appliance to direct the air flow in the desired direction.
Turn on the device using the ON/OFF button.
Select the desired device function.
Select the desired speed.
17
Publicidad
