Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge
is removed before carrying out any work on the
appliance.
CAUTION:
Always wear dust mask during
assembly or maintenance.
Handle connecting
1.
Insert the handle pole fully to the cleaner body as
shown in the figure.
2.
Close the lock latch.
1
2
3
Fig.2
► 1. Handle pole 2. Red marking 3. Lock latch
NOTICE:
Insert the handle fully until the red
marking cannot be seen.
Hose connecting
Insert the hose into the mounting port of the appliance
and turn the hose until it locks.
Fig.3
► 1. Mounting port
1
7 ENGLISH
Pipe connecting
Insert the tip of the aluminum pipe to the joint, and then
attach the aluminum pipe to the pipe holder.
Fig.4
► 1. Joint 2. Pipe holder
NOTICE:
Insert the aluminum pipe in correct
direction as shown in figure. Otherwise the pipe
holder will not be locked and the aluminum pipe may
come off.
Fig.5
Installing or removing battery
cartridge
CAUTION:
Always switch off the appli-
ance before installing or removing the battery
cartridge.
CAUTION:
Hold the cleaner and the battery
cartridge firmly when installing or removing the
battery cartridge. Failure to hold the cleaner and
the battery cartridge firmly may cause them to slip off
your hands and result in damage to the cleaner and
battery cartridge and a personal injury.
CAUTION:
Be careful not to pinch your fin-
gers when installing the battery cartridge. Failure
to do so may cause personal injury.
CAUTION:
Do not install/remove the battery
cartridge with wet hands. There is a risk of electric
shock.
2
1
Publicidad
