Publicidad
Idiomas disponibles
Idiomas disponibles
[] Channel
Selection
Selectchannels byusing[CH. • / V] or [the Numberbuttons].
Use [CH.•
IV]
or [the Number
buttons]
to select the
memorized
channels,
or _.._j
or
_
'_
Using [the Number buttons]
-When
selecting
analog channel
12
-When
selecting
digital channel
12-1
ENT
• Be sure to press l-lENT.]
before entering
the minor
channel
number,
• Press [CH. RECALl Q] to return to the previously
viewed channel,
• When you select a channel
larger than 100, press
[+1OO] first. Then use [the Number
buttons]
to press
the lower 2-digit
numbers,
• Only [the Number
buttons]
can be used to select the
non-memorized
channels,
About digital TV broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality,
What is the minor channel?
By using high compression
technology,
digital
broadcasting
offers a service that enables
multiple
signals to send simultaneously,
Therefore,
you can
select more than one program
per major channel
since
digital
broadcasting
technology
distinguishes
between
multiple
channels
broadcast
by a single network.
NTSC (analog mode)
[AirTime]
ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
major channel
minor channel
: change automatically
=:> : change
manually
by using [CH. A/V]
Note:
• "NO SIGNAL"will appear on the TVscreen after the minor
channel broadcast is over,
[] Volume
Adjustment
Thissection describes h owto adjust the volume.
Themutefunction,whichturnsthesoundoffand on,isalsodescribed.
Use [VOL. • / _] to adjust the audio volume,
or
VOLUME
20
IIIIII
..........
i ,?i_
ii!iiii_!i
i izi!;il
• The volume
bar will be displayed
at the bottom
of the
TV screen when adjusting
the volume,
• The volume
bar display will automatically
disappear
in
a few seconds.
Press [MUTE _] to turn off and on the sound,
MUTE
MUTE
20
IIIIII
..........
• "MUTE" is displayed
on the TV screen
for a few
seconds,
Press [MUTE_N]
again or use [VOL.
_ /
]torecover
the original volume.
[] Switching
Each Mode
Youcaneasilyswitchwith the remotecontroltothe DTV(ATSC) and TV
(NTSC) o rto access e xternaldevices whentheyare connected t o the unit.
ii :iii!
Press [INPUT] repeatedly
to cycle through
the input
modes,
i ;!i:iiii
IC>
iT:J
ii:_!!:i
iNPUT
i
• To use the video or S-video input jack on the unit,
select "VIDEOI ",
• To use the component
video input jacks on the unit,
select "VIDEO2",
• To use the PC input jack on the unit, select"PC",
No te:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. "NOWSCANNING"is displayed while switching
the modes.
EN
Publicidad
