Publicidad
Idiomas disponibles
Idiomas disponibles
Warning:
If the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order
to avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges [2]
using a spanner.
6.
Tilt the lamp in the desired angle and tighten the hinges.
7.
Remote Control
Battery
Refer to illustration [B2] on page 3 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025
(included). Remove the tag from the battery compartment before
use.
1.
To (re)place a battery, press on the side of the battery cover
and pull to slide open.
2.
Insert the battery with the correct polarity and close the battery
compartment by pushing back into the housing of the remote
control until it snaps into place.
Operation
1.
Aim the remote control towards the floodlight to control the
output.
2.
Switch on the floodlight with the ON button on the remote
control. To switch it off again, press the OFF button.
3.
Refer to chapter 5. Overview for more information about
operating the remote control.
8.
Cleaning and Maintenance
All screws should be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the
connections...
Mechanically moving parts must not show any signs of wear and
tear.
The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
V. 02 – 08/04/2015
LEDA3001RGB
8
©Velleman nv
Publicidad
