Publicidad
Idiomas disponibles
Idiomas disponibles
B
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the program button for more
than 5 seconds to enter the water softener setting mode.
3. Press the program button again to select the proper set according to your local
environment, the setting will change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the setting mode.
WATER HARDNESS
German
French
°dH
°fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
1)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
Using the appliance
British
Mmol/l
°Clarke
0 - 6
0 - 0,94
7 - 14
1,0 - 2,0
15 - 21
2,1 - 3,0
22 - 28
3,1 - 4,0
29 - 42
4,1 - 6,0
43 - 69
6,1 - 9,8
24
Regeneration
Water softner
occurs every X
level
program sequence
H1 -> Rapid
No regeneration
Light bright
H2 -> 90 min
Light bright
H3 -> 90 min,
Rapid Light
bright
H4 -> Glass
Light bright
H5 -> Glass,
Rapid Light
bright
H6 -> Glass, 90
min Light bright
EN
Salt consumption
(g/cycle)
1)
0
10
9
5
12
3
20
2
30
1
60
Publicidad
