Qilive Q.6705 Manual De Instrucciones página 14

8. Install the lower hinge on the left side of
EN
the cabinet. Install the adjustable foot at
the right.
9. Remove the screw that secures the
door stop from the bottom right of the
refrigerator compartment door, then
remove the door stop and install to the
bottom left side.
10. Install the refrigerator compartment door.
11. Move the door bushing from the top right
side of the refrigerator door to the top left
side of the door. And move the left hole
cover to the right side.
12. Secure the upper hinge to the top left
side of the cabinet with the three screws
you removed previously. Before you
tighten the upper hinge screws, make
sure that the top of the door is level with
the cabinet and that the rubber gasket
makes a good seal.
4.5. CLEANING BEFORE USE
Clean the parts of the refrigerator with lukewarm water containing a small amount of neutral
detergent, rinse with clear water, and wipe them dry.
Note: Electric parts of the refrigerator can only be wiped with a dry cloth.
4.6. STARTING THE APPLIANCE
• Before plugging in
Check that you have a socket which is compat ble with the plug supplied with the Fridge.
• Before switching on!
DO NOT switch on the fridge until 4 hours after moving it. The coolant fluid needs time to settle.
If the appliance is switched off at any time, wait 30 minutes before switching back on to allow the
coolant fluid to settle.
• Before filling your Fridge
Before storing foods in your Fridge, turn the Fridge on and wait for 24 hours, to make sure it is
working properly and to allow the Fridge to reach the correct temperature.
• Testing
1. Turn the thermostat knob to the "4" position, then connect the power plug to a wall socket.
The fridge begins to work.
2. After 30 minutes, open the door. If the temperature inside the fridge has obviously dropped,
Lower hinge
Screws
Refrigerator door
Door bushing
Hinge cover
Screws
Upper hinge
14
Adjustable foot
Door stop
Hole cover
Hole cover