Publicidad
Idiomas disponibles
Idiomas disponibles
4.2. LEVELLING FEET
To avoid vibration, the unit must be leveled. If required, adjust the leveling feet to
compensate for the uneven floor.
Schematic diagram of the levelling feet:
Lower
Note: The picture above is for reference only. The actual configuration will depend on
the physical product or statement by the distributor.
Adjustment procedures:
1.
Turn the feet clockwise to raise the refrigerator;
2.
Turn the feet counterclockwise to lower the refrigerator;
3.
Adjust the right and left feet based on the above procedures to a horizontal level.
4.3. REVERSING THE DOOR SWING (OPTIONAL)
Tools required:
Phillips screwdriver
(to remove and fasten
Phillips head screws)
5/16" socket and ratchet
(to remove and fasten
hex screws)
Note: The above tools are not supplied.
1.
Power off this appliance before performing this operation. Remove all food from
the door tray.
Tape the door shut with masking tape.
2.
Remove the hole cap, the upper hinge cover, upper hinge screws, upper hinge
and sleeve pipe, then lift the freezer compartment door until it is completely
separated from the cabinet.
hole cap
Raise
11
Putty knife & thin-
blade screwdriver
(to remove hole cap,
upper hinge cover)
Masking tape
(to temporarily fix the
door)
upper hinge cover
upper hinge
sleeve pipe
EN
Publicidad
