Publicidad
Idiomas disponibles
Idiomas disponibles
Read through all assembly steps carefully before beginning the assembly process. Refer to drawings for clarification.
Step 1:
No additional tools are required for assembly. Use gloves
during the assembly procedure.
Two people are recommended for assembly and to
control the frame during assembly.
Lay out all frame sections in a circle (See Fig. 1).
The frame sections consist of:
Top rail - 8 pieces (part no. JKNS14TR)
Top rail with leg socket - 8 pieces (part no. JKWS14TRS)
Curved center leg piece - 3 pieces (part no. JKNLC)
Straight center leg piece - 1 piece (part no. JKNLCW)
Long vertical leg piece - 6 pieces (part no. JKNLS)
Short vertical leg piece - 2 pieces (part no.JKNLSW)
Wheel - 4 pieces (part no. 900355)
These are all interchangeable and have no "left hand" or
"right hand" orientation. All connections consist of sliding
a section tube end (square or round) into a slightly larger
corresponding tube end on the adjacent section. These
are called slip joints.
Step 2:
Now attach a top rail and a top rail with leg socket to
each other. Make sure the spring slot holes are facing
"up" (away from the ground). Complete the circle with
the following sequence:
top rail --- to --- top rail with leg socket--- to --- top rail -
all the way around the circumference. This is now
called the top rail assembly (See Fig. 2).
NOTE: Keep dirt, grass, or other debris out of the
leg socket openings.
Top Rail
Female
Top Rail with Leg
Socket
ASSEMBLY STEPS
Male
Male
1
3
2
1.
2.
3.
4.
5.
6.
7.
FIGURE 1
Join
Female
Top view
5
6
7
Parts:
Top rail
Curved center leg piece
Long vertical leg piece
Top rail with leg socket
Short vertical leg piece
Straight center leg piece
Wheel
Top
Rail
Top Rail
with Leg
Socket
FIGURE 2
4
Page 17
Publicidad
