Jumpking JKWS14WDF Manual Del Usuario página 22

Step 14:
In order to assure proper adhesion of the seam tapes;
carefully clean the surfaces of the pads where they
will be applied with a soft damp cloth. Make sure the
pads are dry before applying the seam tape.
At each seam apply a piece of seam tape by removing the
tape backing and centering the adhesive portion on the top
side of each seam. Approximately 2" of tape will overlap
each edge of the pad. Wrap this around the respective edge
and attach to underside of the pad. Two people make this
assembly easier. One person holding the seams together
and the other person positioning and wrapping the tape
around each edge. The tape can be initially be removed and
repositioned if it is not aligned properly.
After several hours the tape will not be easily removed
without tearing the tape and/or the top surface of the pad. To
remove and store the pad as 12 sections the tape will have to
be cut at the seams. The pad can also be stored in larger
sections. It is recommended that the pad be left on the
trampoline at all times and protected with the weather cover.
Replacement adhesive strips and pad sections are available
from Jumpking.
Tape
Tape should have a
2" overlap at both
ends
Pad
Figure 11
Step 15:
Now attatch the pad assembly to the top rail by pressing
down on the attachment clips so they snap onto the top rail.
You may have to move these slightly clockwise or counter
clockwise to avoid where the springs attach to the top rail.
Push pin through hole and into plastic clip hole
Top frame clip
Spring to trampoline bed (mat)
Top rail
Figure 12
Page 22
Tape over seam
Spring side
Final assembly
Step 16:
Weather Cover (optional part) - This cover should be
placed over the bed and frame pad. Use the attached tie-
down straps to secure the cover to the frame. Tie around
the top rail and a vertical leg extension joint so the cover
will maintain its tension.
Step 17:
Access ladder (optional part) - Hook the ladder over a
top frame rail/vertical leg extension joint area. This should
be at the normal access point. When the trampoline is not
in use, remove the ladder and store in a secure location
(See Figure 13).
FIGURE 13
ASSEMBLY IS NOW COMPLETE.
Make sure that all parts are securely assembled. Familiar-
ize yourself and all users of the trampoline with the care
and maintenance instructions, use and instructional
materials, and warranty and safety precautions contained
in this manual before using the trampoline.
DISASSEMBLY
To disassemble, follow the assembly steps in reverse
order. Do not attempt to disassemble any frame compo-
nents before the mat (bed) and springs have been re-
moved.
CAUTION: Use of this trampoline is not recom-
mended without the frame pad, which is designed to
reduce the likelihood of injury to the user from coming
into contact with the frame of the trampoline. If you
do not have a frame pad, contact your dealer to
obtain a frame pad. Properly install the frame pad
before using the trampoline.
SAFETY
INSTRUCTION
PLACARD